What Alba's Machine Shop Will Do

We perform a five angle valve job to each of your valves. The five angle creates a much better seal than your factory set up, which is typically 3-angle.  A better seal means more power. Our 5-angle valve job also creates much better flow characteristics and improves valve seating for zero leak down. On occasion a valve is past its limit and may need to be replaced but this is not usually the case. In addition to performing a valve job we will dissemble clean surface and reassemble your head. 

The cost for this service is $50 per valve.  
If there are any problems with your head we will contact you.
Additional charges may apply.

(We recommend at this time to replace the valve stem seals average cost is only about $5 per valve. This ensures that there will be no problems.)

For Information on Alba's
Machine Shop Services and
to receive a quote on a specific job....

Contact: Alba Performance
Email: performance@albaaction.com
Phone: 858.413.2556